2.75" 2 3/4" Lap Joint Seal Exhaust Clamp Bear River Quality Stainless
This listing is for one (1) Lap Joint Clamp in the size described.
All other clamps pictured are for style reference only!
Bear River LJC275SS 2.75" (2 3/4") Lap Joint Clamp
Seals Lap Joint Connections Where 2.75" (2 3/4") ID Pipe Slides Over 2.75" (2 3/4") OD Pipe
Overall Length: 3"
Height: 3.71875" (3 23/32")
Hex Nut: 14mm Metric
Material: T304 Stainless Steel w/ Zinc-plated Mild Steel Hardware
What you need to know about exhaust clamps:
U Bolt “Economy” Clamp
The most common type of clamp is the U-bolt or saddle clamp. The most cost effective of all the clamps, people choose this one most often because it does a good job at a low cost.
Band clamps utilize a strong band which is tightened around the joint. Depending on the design, this type of clamp is less prone to leaks, and is a good way to secure parts together without the use of welds.
“Lap-Joint” Band Clamp
Lap-joint clamps are best when cosmetic appearance is important, as well as serviceability of the joint. This would include exhaust tips, mufflers, catback systems, racing exhaust, and show cars. This type of clamp is much easier to separate should a component ever need to be removed or replaced, so if disassembly is important, this clamp would be preferred over band or saddle clamps. This type of clamp does require that the sections being clamped have sufficient lengths of straight pipe leading into it.This clamp will not work properly if installed too closely to a bend.
“Butt-Joint” Band Clamp
Butt-joint clamps are also a good choice when cosmetic appearance is important. This type of clamp is for connecting two pipes that have the same outside diameter.
Reaction block and forced bar for complete inner circle seal and conforms to the pipe upon installation. This type of clamp does require that the sections being clamped have sufficient lengths of straight pipe leading into it.This clamp will not work properly if installed too closely to a bend.
We Also Recommend
2 3/4" 2.75" Butt Joint Band Exhaust Clamp Bear River Quality Stainless
QUESTIONS & ANSWERSAsk a Question
The lap joint LJC275SS smaller inside diameter is for a pipe 2.75" o.d. , now the bigger inside diameter will accept a 2.75" id but what is the od that fit correctly (dépend of the wall thickness). Because I have to install a 3" résonator on a 2.75" exh pipe, so the 3" end of the résonator will it go in the bigger side of this lapjoint.
On the lap joint clamps, the larger side will accomodate about 1/8" larger than the small side.
So the max it could handle on a 2 3/4" clamp would be 2 7/8".
We recommend using a pipe adapter in your situation. We can put together a quote for everything you need if you like?